BXT3 – V2.3
ARCURE SA – 14, rue Scandicci – 93500 Pantin – France - Tel.: +33 144 068 190
www.arcure.net
09/05/2019 38/41
9 Appendices
9.1 Data recorded by BLAXTAIR®
9.1.1 Download to an external hard drive
To download the data recorded by BLAXTAIR®, including video, only a
storage device provided by Arcure can be used.
• Switch on BLAXTAIR®;
• Once the screen displays the camera view, plug the backup device
into the USB port on the Processor (If optional LED is fitted, remove
the connector on the processor to allow access for the ‘download
tool’). After few seconds, a maintenance page will be displayed on
the screen with messages in the right top corner, indicating the
progress of the backup;
• Wait until the backup is complete. You will be warned by a message
displayed on the screen inviting you to disconnect the storage
device. The transfer may take from a few minutes to a couple of
hours depending on the volume of data to be transferred;
• Unplug the backup device. BLAXTAIR® restarts automatically in
detection mode; (If the LED option was disconnected , the system
must be rebooted to restore the LED function)
• Return the backup device to Arcure’s customer support.
9.1.2 Viewing Downloaded Data
Plug the external hard drive containing the downloaded data into a PC. On the
HDD, video files are stored in the file data.
They can be displayed by using VLC software
To Next Page
Loading...
