ARCURE BLAXTAIR 3 - Automatic Software Update

BXT3 – V2.3
ARCURE SA – 14, rue Scandicci – 93500 Pantin – France - Tel.: +33 144 068 190
www.arcure.net
09/05/2019 39/41
9.2 Automatic software update
To perform the update, you need an update device provided by Arcure.
Be sure to maintain a good power supply to the BLAXTAIR® system during
the update. A low voltage or a power failure may cause irreversible damage
to the processing unit.
• Start up BLAXTAIR®;
• Once the monitor displays the camera view, plug the update device
to the USB maintenance connector. After few seconds, a
maintenance page is displayed on the screen with messages in the
right top corner, indicating the progress of the update;
• Wait until the update is complete. You will be warned by a message
displayed on the screen inviting to disconnect the update device.
The update may take several minutes (rarely more than ten
minutes);
• Unplug the update device. BLAXTAIR® restarts automatically in
detection mode. Verify the detection according to the procedure
detailed in section 4.3.1 ;
• Return the update device to Arcure’s customer support.