BXT3-V2.3
ARCURE SA – 14, rue Scandicci – 93500 Pantin – France - Tel.: +33 144 068 190
www.arcure.net
09/05/2019 18/41
The mirror display mode is enabled or not during installation, according to the
positioning of the sensor head.
5.3 Detection/danger area
The detection area (also called danger area), has been defined by your
installer according to your needs and constraints.
It is generally composed of two separate sub-zones:
• an « obstacle » sub-zone where any obstacle, pedestrian or not,
triggers an alarm;
• a « pedestrian » sub-zone where only pedestrians trigger alarms.
5.4 Alarm trigger
The BLAXTAIR® System is unique in its ability to detect only pedestrians
Combined with the set detection zones, only active in the direction of travel,
it dramatically reduces the constant ‘nuisance’ alarms encountered by other
systems
The alarm will only sound if there is a person in the ‘Pedestrian Zone’ with
the option of a small ‘Obstacle Zone’ to protect the rear of the vehicle, if
required
The main complaint expressed by operators is of constant warnings emitted
by so called ‘safety systems. Apart from the fact that an operator will choose
to ignore these constant alarms they can also cause mental fatigue which can
lead to loss of concentration, promoting the likelihood of accidents as opposed
to reducing them.
To Next Page
Loading...
