arcweld 210C MIG - Page 22

E-3 OPERATION E-3
8. 【Voltage Knob】
For voltage preset before welding in MIG mode.
9. 【Amp/WFS knob】
MMA and TIG mode: for welding amperage adjustment
MIG mode: for wire feeder speed adjustment
10. 【Amp/WFS display】
MMA and TIG mode:
For amp preset before welding, and display actual amperage in welding.
MIG mode:
For WFS preset before welding, and display actual amperage in welding.
11. 【Amp light】
When amp light is on, the amp display shows amps.
12. 【M/min light】
When M/min light is on, the current display shows wire feeder speed for preset.