Host product manufacturers that they need to provide a physical or e-label stating, “ContainsFCCID:2AN9S-
ABX00046” with their finished product.
Only those antennas with same type and lesser gain filed under this FCC ID can be used with this device.The host
product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by
the modular transmitter grant of certification.The final host product still requires Part 15 Subpart B compliance
testing with the modular transmitter installed.
The final host integrator must ensure there is no instruction provided in the user manual or customer
documentation indicating how to install or remove the transmitter module except such device has implemented
two-ways authentication between module and the host system.
The final host manual shall include the following regulatory statement: This equipment has been tested and found
to comply with the limits. This device complies with Part 15 of the FCC Rules.Operation is subject to the following
two conditions:(1) This device may not cause harmful interference, and(2) this device must accept any interference
received, including interference that may cause undesired operation.
This module has been tested and found to comply with part 15.247 requirements for Modular Approval. This
module is intended for OEM integrator.The OEM integrator is responsible for the compliance to all the rules that
apply to the product into which this certified RF module is integrated. Additional testing and certification may be
necessary when multiple modules are used.
Frequency bands Maximum output power (ERP)
2402-2480MHz (BLE) 8.23dBm
2402-2480MHz (EDR) 2.23dBm
2412-2472MHz (2.4G WIFI) 18.41dBm
9 Company Information
Company name Arduino SRL
Company Address Via Andrea Appiani 25 - 20900 Monza (MB)
To Next Page
Loading...
Need help?
General
