Arduino WisGate Edge Pro

Note: the SD card and the SIM card do not support hot-swap. Please always turn off the
gateway before you insert or take off SIM or SD card.
Note: Do not power the Gateway without a connected antenna/s. This may damage the
radios.
5 Status LEDs
Name
Status
Description
PWR
ON/OFF
• ON – device power on
• OFF –device power off
ETH
ON/OFF/FLASH
• ON – link up
• OFF – link down
• Flash - Data Transmitting and Receiving
LoRa1
ON/OFF/FLASH
• ON - LoRa1 is working
• OFF - LoRa1 is not working
• Flash - Indicate that LoRa1 Packet Transmitting and
Receiving
LoRa2
ON/OFF/FLASH
• ON - LoRa2 is working
• OFF - LoRa2 is not working
• Flash - Indicate that LoRa2 Packet Transmitting and
Receiving
WLAN
ON/OFF/Slow
FLASH/FLASH
•OFF-Wi-Fi disable
AP Mode
• ON - WLAN is working
• Flash - Data Transmitting and Receiving
STA Mode
• Flash slowly (1Hz) - Connection Disconnected