Original User Manual – AREBOS Mini Heat Pump
9
5 Location and connection
ATTENTION:
Please observe the following rules when installing the heat pump.
1. Any addition of chemicals must take place in the piping located downstream from the heat
pump.
2. Always place the heat pump on a solid foundation and use the included rubber mounts to
avoid vibration and noise.
3. Always hold the heat pump upright. If the unit has been held at an angle，wait at least 24
hours before starting the heat pump.
4. DO NOT place the unit next to shrubs which can block the air inlet. These locations deny the
unit a continuous source of fresh air which reduces its efficiency and may prevent adequate
heat delivery.
Heat pump location
The unit will work properly in any desired location as long as the following three items are present:
1. Fresh air
2. 2.Electricity
3. 3.Swimming pool filters
The unit may be installed in virtually any outdoor location as long as the specified minimum
distances to other objects are maintained (see drawing upon). Please consult your installer for
installation with an indoor pool. Installation in a windy location does not present any problem at all,
unlike the situation with a gas heater (including pilot flame problems).
To Next Page
Loading...