ENGLISH
CLEANING, MAINTENANCE AND STORAGE
WARRANTY TERMS
When the alarm goes off, press the SNOOZE button. The alarm will sound again after 9 minutes. If the SNOOZE button is not pressed, the alarm
will turn off after 10 operations and the next time it will work only the next day at the same time.
TRANSPORTATION. Transportation of the device is necessary by any kind of covered transport with the application of cargo securing rules
ensuring preservation of the presentation of the product and / or packaging and its further safe operation. DO NOT expose the device to shock
loads during handling operations.
CLEANING. Before cleaning, turn off the radio clock power. It is recommended to wipe the cover, display and buttons with a damp cloth. Do no
t use abrasive cleaners, detergents containing powder, alcohol, gasoline, or various chemicals.
STORAGE. The device must be stored indoors, in conditions that presume the preservation of the presentation of the product and its further safe
operation. To avoid damaging the cord, do not wind it on the body.
When purchasing the product, ask for it to be checked in your presence. Without the having a warranty card or when it is not properly filled in,
the quality claims are not accepted, and no warranty repair is performed. The warranty card should be presented at any address to the service
center during the whole warranty period. The product is accepted for service in a complete set only. The warranty period is calculated from the
moment of sale to the buyer. Keep the documents confirming the date of purchase of the product (cash receipt).
The condition of free warranty service of your product is its correct operation, which does not go beyond personal domestic needs, in accordance
with the requirements of the operating instructions for the product, the absence of mechanical damages and the consequences of careless
handling of the product.
The product is accepted for warranty service in its pure form. The warranty covers all manufacturing and construction defects (except those
listed in the "Warranty does not apply" section), identified during the warranty period. During this period defective parts, except consumables,
are subject to free replacement in the warranty service center.
THE GUARANTEE DOES NOT COVER:
1. Defects caused by force majeure.
2. Damage to the product caused by the use of the product for purposes that go beyond personal domestic needs (ie industrial or commercial purposes).
3. Consumables and accessories (sections, etc.).
4. Defects caused by overloading, improper operation, penetration of liquids, dust of insects, ingress of foreign objects into the product.
5. Products that have been repaired outside authorized service centers or warranty workshops.
6. Damage resulting from changes in the design of the product by the user or unqualified replacement of his components.
7. Mechanical damages, including due to negligent handling, improper transportation and storage, falling of the product.
8. Violation of the operating instructions.
9. Incorrect installation of mains voltage (if required).
10. Making technical changes.
11. Damage through the fault of animals (including rodents and insects).
Production month: refer to the date on the gift box
For warranty service, please contact your nearest service center.
REPEATED ALARM CLOCK SIGNAL
In the time display mode, press the DIMMER button to adjust the brightness of the display. You can choose the following brightness values: very bright-bright-dim. By
default, the brightness value is set to BRIGHT.
BRIGHTNESS ADJUSTMENT
RADIO TUNING
1) Press and hold the POWER button to turn the radio on (off). To switch the AM / FM bands, press the BAND button. By default, the radio is tuned in the FM band. The
corresponding range is shown on the display.
• Press the TUN + button to search the nearest station up the range. Hold this button to speed up the search process.
• Press the TUN- button to search for the nearest station down the range. Hold this button to speed up the search process.
• Press the VOL + button to increase the volume. Holding down this button allows you to increase the volume faster. There are 16 volume levels in this device. The
volume is displayed on the display.
• Press the VOL- button to decrease the volume. Holding down this button allows you to decrease the volume faster. There are 16 volume levels in this device. The
volume is displayed on the display.
• To display the frequency of the radio station, press TUN + or TUN-.
2) Preservation of radio stations.
To save a found station, you must:
- Press the MEMORY button, then PXX appears on the display;
- Select the number to store the desired station using the CH + and CH- buttons;
- After selecting the desired memory location, press the MEMORY button to store the radio station.
3) Enable the stored radio station. In radio mode, press the CH + or CH- button to select the memory location (P01-P20) into which the radio station was saved.
The corresponding station number will be displayed on the screen.
4) Automatically search and store radio stations. In radio mode, press and hold the SCAN button to automatically search for radio stations. Each found radio station will
be played back for 3 seconds and stored in memory.
5) This unit can store up to 20 stations for each band.
Attention!
After the power is turned off, the stored radio stations are not stored in memory.
Also, when you disconnect from the power supply of the radio, the device will not work. Batteries (2xAAA) are only needed to save time settings.
• When process is completed, switch off and unplug the unit.
To Next Page
Loading...