17
V 01/12
FOR OPTIMAL REMOTE CONTROL FUNCTION, POINT THE HEAD OF THE TRANSMITTER TOWARDS
THE RECEIVER ON THE AIR-CONDITIONER.
(1) SIGNAL TRANSMITTER
(2) FUNCTION DISPLAY
(3) FUNCTION SELECTION BUTTON (FUNCT)
Press this button to select the different operating modes, according to the following sequence:
Cooling → Dehumidification → Heating (NOT ACTIVE) → Fan
(4) TEMPERATURE ADJUSTMENT BUTTON
(▲▼)
Increase (▲):
1) Enables the adjustment of the temperature desired in Cooling and Heating modes.
2) Each time the (▲) button is pressed, the temperature set increases by 1ºC; by holding the button pressed, the
temperature increases continuously.
Decrease (▼):
1) Enables the adjustment of the temperature desired in Cooling and Heating modes
2) Each time the (▼) button is pressed, the temperature set increases by 1ºC; by holding the button pressed, the
temperature increases continuously.
(5) ON/OFF BUTTON (POWER)
Press the POWER button to switch the unit on or off.
When switched on, the appliance will start to operate as it was last set (save function).
Remote control receiver
To Next Page
Loading...
Need help?
General
