Argo Glamour - Care and Maintenance

26
V 12/16
(7) “FAN” BUTTON
Press “FAN” to start the Ventilation mode.
(8) “HEAT” BUTTON
Press “HEAT” to start the heating mode.
(9) “COOL” BUTTON
Press “COOL” to start the refrigeration mode.
(10) “DRY” BUTTON
Press “DRY” to start the dehumidification mode.
Note: Only when temperature reaches 16°C can we turn on the dehumidification mode, besides, the drain pipe must be
installed.
CARE AND MAINTENANCE
WARNING!
Before carrying out any cleaning or maintenance operations, unplug the appliance.
1. Cleaning the air filters
The air filters must be checked at least once every two weeks
of use. Operating the appliance with dirty or clogged filters will
decrease the air conditioner's efficiency and may cause
serious problems.
To remove filter 1, detach the grille by pressing the upper fin.
To remove filter 2, detach the grille by pressing the upper fin.
Use a vacuum cleaner to remove the dust from the filters.
Should this not suffice, wash the filter with lukewarm water
and some neutral detergent (if necessary), then rinse it
thoroughly in cold water and leave it to dry in air before
putting it back in place. Once the filter has been replaced,
close the grille and resume use of the air conditioner.