V 06/20
46
(1) ON/OFFBUTTON
Press this button to switch the unit on or off.
When switched on, the appliance will start functioning based on its last settings (save function).
(2) MODE SELECTION BUTTON (MODE)
Press this button to select the various operating modes, according to the following sequence:
In the COOL mode the display lights up. In the DRY and FAN modes the display does not light up.
(3) TEMPERATURE + - AND TIMER ADJUSTMENT BUTTONS
The temperature can be adjusted to between 16 °C and 30 °C.
Increase temperature（+):
1) Allows for adjusting the desired temperature in cooling (COOL) mode.
2）Whenever the（+) button is pressed, the set temperature increases by 1 °C.
Decrease temperature (- ):
1) Allows for adjusting the desired temperature in cooling (COOL) mode.
2）Whenever the ( - ) button is pressed, the set temperature decreases by 1 °C.
The same button allows for setting the TIMER.
(4) FAN SPEED ADJUSTMENT BUTTON
Press this button when the appliance is switched on for adjusting the ventilation speed in cooling mode (AUTO), to low
(Low), medium (Med) or high (High).
The fan speed cannot be adjusted in DRY mode and is fixed to low speed.
(5) WIFI BUTTON (on both the remote control and portable unit)
Press this button to turn on/off the WiFi function. When the WiFi is on the LED is lighted on.
To reset WiFi settings hold this button for 10 seconds.
(6) “SWING” BUTTON
Press “SWING” top turn on or off the swing function.
X-FAN BUTTON ((on the remote control)
Pressing the X-FAN button in cooling or dehumidification mode, when the power is turned off the fan
continues to operate for about 2 minutes to completely dry the evaporator.
SLEEP BUTTON (on the remote control)
To Next Page
Loading...
Need help?
General
