To Next PageTo Next PageWhat causes creaking noises in my Argo X3I ECO PLUS?
Creaking or cracking noises from your Argo Air Conditioner are due to the friction caused by the expansion and contraction of the panel or other parts because of temperature changes.
Why does my Argo Air Conditioner sound like running water?
The sound of running water in your Argo Air Conditioner is produced by the refrigerant flowing inside the unit, which is a normal phenomenon.
What to do if my Argo X3I ECO PLUS is not working?
If your Argo Air Conditioner isn't working, try these steps: First, ensure the unit is properly plugged in. If it is, check the circuit breaker or fuse and have it replaced by a qualified technician if necessary. If there was a power outage, wait for the power to be restored. You can also try waiting 3 minutes before restarting the unit or resetting the function.
Why does my Argo Air Conditioner produce mist from the indoor unit?
If the indoor unit's air outlet of your Argo Air Conditioner produces a mist, this occurs when indoor air cools rapidly. Wait for the indoor temperature and humidity to fall, and the mist should disappear.
What to do if my Argo Air Conditioner turns on suddenly?
If your Argo Air Conditioner turns on suddenly, disconnect the power supply and then reconnect it. Turn the unit on again.
Why can't I adjust the temperature on my Argo X3I ECO PLUS?
If the set temperature on your Argo Air Conditioner cannot be adjusted, it may be in automatic mode. Change the operating mode if you want to adjust the temperature. Also, ensure that the temperature you are trying to set is within the range of 16 – 30°C.
How to stop Argo X3I ECO PLUS Air Conditioner from emitting bad smells?
If your Argo Air Conditioner is emitting unpleasant smells, try to eliminate the odour source and clean the filter.
Why no air comes out of my Argo X3I ECO PLUS indoor unit?
If no air is coming out of the indoor unit of your Argo Air Conditioner, check for obstructions blocking the airflow. Also, the unit will stop blowing air once the set temperature is reached. If the unit has just been turned on, there may be a delay of several minutes to prevent blasts of cold air.
How to fix Argo X3I ECO PLUS remote control not working?
If your Argo Air Conditioner remote control isn't working or the indoor unit isn't receiving the signal, try these steps: Ensure you're within 8 meters of the unit and that there are no obstacles. Point the remote directly at the receiver on the indoor unit. Check and replace the batteries if they are low. If the remote is damaged, replace it. You can also try pulling out the plug, waiting about 3 minutes, and then reinserting it to restart the unit.
Why my Argo Air Conditioner is not cooling/heating enough?
If you can't achieve the desired heating or cooling level with your Argo Air Conditioner, it might be due to low voltage. Wait for the voltage to return to normal. Also, a dirty filter can cause this issue, so clean the filter. Ensure that you adjust the temperature to within the available range and close all doors and windows to maintain the desired temperature.
General| Cooling Capacity | 9000 BTU/h |
|---|---|
| Cooling Power | 800 W |
| Energy Efficiency Class Cooling | A++ |
| Refrigerant | R32 |
| Power Supply | 220-240V/50Hz |
