1. Place iNet2+ on a suitable shelf or table
2. Connect the power adaptor between iNet2+ and the mains supply.
3. To receive broadcast radio (DAB and FM), extend the telescopic antenna.
The setup wizard starts.
3.1 Setup wizard
When iNet2+ is started for the first
time, it runs through a setup wizard to
configure settings for date/time and
network. Once this has finished, the
system is ready to use in most modes.
Note: To change these settings later,
select Menu > System settings >.
To run the setup wizard again, select
Menu > System settings > Setup
To Next Page
Loading...
