11.2 Setting up the connection to the iNet2+
After you download the Wireless Device Remote Control application, you must set up a connection
between the iPhone/Android and the iNet2+. To do this, follow these steps:
1. On the iNet2+, navigate to Menu > Main menu > System settings > Network > Keep
network connected, and select YES.
The network connection now stays on when the device is in standby mode. This setting is
retained in the device’s memory after it is switched off and on again.
2. Set the iPhone/Android to use the same network access point as the iNet2+., as follows:
a. Select Settings > Wi-fi.
b. Choose the network of the iNet2+. from the list.
c. Default PIN code is 1234
To Next Page
Loading...
