FOR MODELS: JGI, JGM, JGN, JGP AND JGQ SECTION 5 - MAINTENANCE
PAGE 5-10 9/08
after installing new bearings, bushings, etc., contact your packager or Ariel
before proceeding.
8. Examine the top cover or access cover gaskets. If there is any doubt about their
condition, install new gaskets. Before installing a gasket, apply an antiseize
lubricant to both sides or to the metal seating surfaces. This will help to hold the
gasket in place during assembly and aid in easy of removal. Additional lubrica-
tion to provide for gasket release, is not required. Replace the top cover or
access cover and crosshead guide covers. Tighten all cover cap screws hand
wrench tight.
To Next Page
Loading...
