EasyManua.ls Logo

Ariens 27-Ton Log Splitter - User Manual

Ariens 27-Ton Log Splitter
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Models
917001 – 27-Ton Log Splitter
917002 – 34-Ton Log Splitter
Log Splitter
03860300F 10/11
Printed in USA
ENGLISH
FRANÇAIS
ESPAÑOL
Owner/Operator Manual
Manuel Du Propriétaire/Utilisateur
Manual del propietario/operador
Gasoline containing up to 10% ethanol (E10) or up to 10% MTBE (methyl tertiary butyl ether) is acceptable for
use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) or 10% MTBE will void the product warranty.
Il est possible d'utiliser de l'essence contenant jusqu'à 10% d'éthanol (E10) ou 10% de MTBE (éther méthyl-
tertiobutylique) sur cette machine.
L'utilisation d'une essence contenant plus de 10% d'éthanol (E10) ou de 10% de MTBE annulent la garantie.
En esta máquina puede utilizarse gasolina con hasta un 10% de etanol (E10) o hasta un 10% de MTBE (éter
de metil butil terciario).
El uso de cualquier otro tipo de gasolina con un porcentaje superior al 10% de etanol (E10) o al 10% de MTBE
invalidará la garantía del producto.

Questions and Answers

  • K
    Katherine LopezJul 26, 2025
    Why won't my Ariens 27-Ton engine start?
    • A
      Amanda RichardsJul 26, 2025
      There are several reasons why your Ariens Log Splitter engine might not start: * The engine switch may be in the Off position. Move it to the On position. * The fuel shut-off valve may be in the Off position. Move the valve to the On position. * The fuel tank may be empty. Refill the fuel tank. * The spark plug may be disconnected. Connect the spark plug. * The spark plug may be faulty. Replace the spark plug. * The choke lever may be in the wrong position. Adjust the choke lever position.
  • H
    Henry JensenJul 31, 2025
    What to do if my Ariens 27-Ton cylinder does not extend or retract?
    • R
      robertmillerJul 31, 2025
      If the cylinder on your Ariens Log Splitter isn't extending or retracting when you move the control lever, it could be due to several reasons: * The hydraulic oil level might be low. Refill the hydraulic oil to the proper level. * The hydraulic lines might be kinked or pinched. Repair or replace any damaged hydraulic lines. * The hydraulic drive coupling might be broken. Replace the hydraulic drive coupling.
  • D
    Denise Lang DDSAug 5, 2025
    Why is my Ariens Log Splitter engine overheating?
    • R
      Renee FernandezAug 5, 2025
      If your Ariens Log Splitter engine is overheating, it is possible that debris has accumulated on the engine and cooling fins. Clean the debris from the engine and cooling fins.
  • M
    Mark HayesAug 10, 2025
    What causes erratic movement of the cylinder in my Ariens 27-Ton Log Splitter?
    • L
      Lori BarnesAug 10, 2025
      Erratic cylinder movement in your Ariens Log Splitter is often due to air in the hydraulic system. Purge the air from the hydraulic system.
  • M
    mcbrideshawnAug 15, 2025
    Why is there excessive vibration or noise from the hydraulic drive coupling on my Ariens Log Splitter?
    • E
      Erin MoyerAug 15, 2025
      Excessive vibration or noise from the hydraulic drive coupling on your Ariens Log Splitter is likely due to a worn or damaged drive coupling. Replace the hydraulic drive coupling.
  • A
    Andrea PowellAug 20, 2025
    How to fix a control lever that sticks on Ariens 27-Ton?
    • A
      alexisperezAug 20, 2025
      If the control lever on your Ariens Log Splitter is sticking, it may be due to debris in the control lever linkage. Clean and lubricate the linkage.

Summary

INTRODUCTION

THE MANUAL

Explains the importance of reading the entire manual for safe operation and understanding.

ENGINE MANUAL

Refers to a separate manual covering engine-specific service recommendations and operation.

DELIVERY

SAFETY

SAFETY DECALS AND LOCATIONS

Details the importance of safety decals and their placement on the unit for user awareness.

OPERATOR ZONE

SAFETY RULES

ASSEMBLY

Assemble Tongue Assembly

Instructions for attaching the tongue assembly to the log splitter frame, including bolt and nut procedures.

ASSEMBLY

Purge Hydraulic System and Add Hydraulic Oil

Step-by-step guide for removing air from the hydraulic system and adding the correct hydraulic oil.

Fill Engine Fuel Tank

Instructions for safely filling the engine's fuel tank, emphasizing not to overfill.

CONTROLS AND FEATURES

OPERATION

Control Lever

Describes the function and operation of the control lever for moving the splitting wedge in horizontal or vertical positions.

OPERATION

Front Jack Stand

Instructions for correctly positioning and locking the front jack stand for use and transport.

Rear Stabilizer

Guidance on positioning and locking the rear stabilizer for stable operation or transport.

OPERATION

Start Engine

Step-by-step procedure for starting the log splitter's engine, including choke and throttle settings.

TRANSPORTING UNIT

Safety precautions and procedures for safely towing the log splitter, including securing components.

OPERATION

Splitting Logs

Detailed instructions on how to safely and effectively split logs using the log splitter.

FOR BEST PERFORMANCE

Tips and guidelines to optimize the log splitting process and ensure efficient operation.

MAINTENANCE SCHEDULE

HYDRAULIC OIL SYSTEM

Changing Hydraulic Oil and Filter

Step-by-step instructions for replacing the hydraulic oil and filter, including necessary cleaning and preparation.

STORAGE

Fuel System

Advice on using fuel stabilizer and preparing the fuel system for storage to prevent gumming and damage.

TROUBLESHOOTING

SPECIFICATIONS

Limited Warranty

Customer Responsibilities

EVAPORATIVE EMISSION CONTROL WARRANTY STATEMENT

OWNERS WARRANTY RESPONSIBILITIES

Outlines the owner's duties regarding maintenance, presenting the unit for service, and proper usage.

Ariens 27-Ton Log Splitter Specifications

General IconGeneral
Horsepower6.5 HP
Splitting Force27 Tons
Log Capacity24 inches
OrientationHorizontal
Beam TypeI-beam
Fuel TypeGasoline

Related product manuals