Ariens 921024 - Maintenance

EN - 26
TRAVELING
To travel from one work area to another:
1. Set Throttle to Slow or Part-Throttl
e
po
sition.
2. Models 921024, 028, 029, 030, 032,
035, 036, 037: Press down on
handlebars enough to raise front of unit
slightly off surface.
3. Model 921023: Place the unit in t
he
t
ransport position (see Track Angle on
page 22).
4. Engage traction drive clutch lever
without engaging attachment drive
clutch.
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
SERVICE POSITION
(Figure 24)
1. Shut off engine, remove key, disconnect
spark plug wire and allow unit to
cool
c
ompletely.
2. Close fuel shut-off valve (see Fuel Shut-
Off Valve on page 23).
3. Drain fuel tank and fuel system
(see
E
ngine Manual for complete
instructions).
4. Place unit on a flat level surface. Tip unit
forward onto front of auger housing fo
r
se
rvice.
IMPORTANT: Ensure unit is secure and will
not tip over. Strap and clamp onto bench if
needed.
MAINTENANCE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur. Ensure unit is
secure and will not tip over during
maintenance.
Figure 24
Service Position