6. Secure cable eye to control lever with sleeve bushing and
hairpin.
7. Using the wire hook attached to the deflector cable, hook
cable to discharge chute crank.
8. Install cable into clip on top of discharge chute pedestal.
9. Make sure deflector cable loops above gear cover between
cable clip and cable support bracket.
10. Test controls to be sure deflector works properly.
NOTE: If deflector does not follow full range of travel See Remote
Discharge Deflector Control Adjustment in Owners Manual.
Step Four: Install Remote
Deflector Cable Cont.
To Next Page
Loading...
Need help?
General
