To Next PageTo Next Page
Need help?Do you have a question about the Ariens Compact 24 LE and is the answer not in the manual?
General| Product Type | Two-Stage Snow Blower |
|---|---|
| Engine Displacement | 208cc |
| Drive Type | Wheel Drive |
| Electric Start | Yes |
| Engine Type | 4-Cycle |
| Clearing Width | 24 in |
| Number of Speeds | 6 Forward / 2 Reverse |
| Start Type | Electric Start |
| Housing Height | 21 inches |
| Throwing Distance | 40 feet |
| Skid Shoes | Yes |
| Warranty | 3-Year Limited |
| Engine | Ariens AX 208cc |
Instructions for unfolding the lower handlebar assembly.
Attaching the upper handlebar assembly to the lower handlebar.
Connecting the attachment and traction control cables to the machine.
Unfolding the upper handlebar assembly into the operating position.
Routing and connecting the headlight wire harness to the engine electrical plug.
Instructions for units with pre-attached upper handlebars.
Greasing the chute ring and mounting the discharge chute to the auger housing.
Installing the chute crank mechanism and securing the pedestal hardware.
Attaching the remote deflector cable snap fitting to the bracket.
Securing the cable eye, connecting to the crank, and testing deflector function.
Verifying clutch lever engagement/disengagement for safe operation.
Instructions to check and adjust tire pressure according to sidewall specifications.
Guidance on adjusting skid shoes for hard or uneven surfaces.
Procedure for checking the oil level in the auger gearcase.
Important note: check engine oil as per the Engine Manual.
Instructions for filling the fuel tank, warning against overfilling.
Move the throttle control lever to the fast position.
Turn the fuel shut-off valve to the "ON" position.
Insert the key and turn it to the on/start position.
Turn the choke control knob to the choke position.
Push the primer bulb two times, covering the vent hole.
Firmly hold and pull the starter cord handle to start the engine.
Connect the extension cord to the receptacle and wall.
Depress the push button and disconnect cords after starting.
Allow the engine to warm up before moving choke to run position.
Turn key to off, move throttle to stop, remove key, close fuel valve.
Contact details for Ariens Company and Briggs & Stratton support.
