Ariens HYDROSTATIC S-12 - Page 3

DECALS FOR HYDROSTATIC MODELS 931015, 931016, 931017, & 931018
4
MYCZlRa
i-ll TU/
Dl
(LEFT SIDE
DECAL SHOWN)
78464 L.H. S-18H 78415 L.H. S-16H
78463 R.H. S-18H 78414 R.H. S-16H
78413 L.H. S-14H
78412 R.H. S-14H
78411 LH. S-12H
78410 R.H. S-12H
SELECTOR
78278
.^Hk'RFA«
AR UFT
<1 M I N' -Al .1
78391
COMPLIANCE WITH CANADIAN RADIO INTERFERENCE REGULATIONS CERTIFIED
_ REPLACE SPARK PLUG WITH RESISTOR SPARK PLUB ONLY I _
CERTFIE CONFORME AU REGLEMENT CANADIEN SUR LE BROUILLACE RADIOELECTRIQUE |
REMPLACER LA ROUGIE PA R UNE ROU GIE A RESISTANCE SEULEMENT I
78400
(UNDER HOOD NEXT TO SPARK PLUG)
BE AWARE OF SAFETY DECALS
15. When using any attachments, never direct discharge of
material toward bystanders norallow anyone near the vehicle
vyhile in operation.
16. Handle gasoline with care—it is highly inflammable.
a. Use approved gasoline container.
b. Never remove the cap of the fuel or add gasoline to a
running or hot engine, or fill the fuel tank indoors. Wipe
up spilled gasoline.
c. Open doors if the engine is run in the garage—exhaust
fumes are dangerous. Do not run the engine indoors.
17. Keep the vehicle and attachments in good operating con-
dition, and keep safety devices in place.
18. Keep all nuts, bolts, and screws tight to be sure the equip-
ent is in safe working condition.
19. Never store the equipment with gasoline in the tank inside a
building where fumes may reach an open flame or spark. Al-
low the engine to cool before storing in any enciosure.
20. To reduce fire hazard, keep the engine free of grass, leaves,
or excessive grease.
21. The vehicle and attachments should be stopped and in-
spected for damage after striking a foreign object, and the
damage should be repaired before restarting and operating
the equipment, see numbers 6 & 7 opposite page.
22. Do not change the engine governor settings or overspeed the
engine.
23. When using the vehicle with mower, proceed as follows:
a. Mow only in dayiight or in good artificial light.
b. Never make a cutting height adjustment while the engine
is running if the operator must dismount to do so.
c. Shut the engine off when removing the grass catcher or
unciogging chute.
d. Check the blade mounting bolts for proper tightness at
frequent invervals.
24. Check the grass catcher bags frequently for wear or de
terioration. Replace with new bags for safety protection.
Page 3