GB - 9
ASSEMBLY
NOTE: The mounting hardware described in
the following assembly procedures is factory-
mounted on the mower in the proper
locations.
Handlebar Installation
1. Remove mower, handlebar and
discharge chute from carton. See
Figure 3.
2. Pull both handlebar supports back to
vertical position.
3. Remove handlebar mounting hardware
from mower frame.
4. Place the lower hole of one end of the
handlebar on frame stud. Spread lower
ends of handlebar until the opposite end
can be installed on frame stud. See
Figure 4.
5. Install flanged lock nuts on studs. Do not
tighten fully.
6. Install round head square neck bolts
through upper holes in frame and
handlebar and secure loosely with
flanged lock nuts. See Figure 5.
7. Slide each support clamp on handlebar
to align with vertical support and connect
with hex cap screw and flanged lock nut.
See Figure 5.
8. Tighten all mounting hardware installed
in steps 5 through 7.
9. Tighten hardware securing lower end of
each handlebar support to frame.
ASSEMBLY
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Figure 4
Handlebar
Support
Handlebar
Frame
Stud
Figure 5
Handlebar
Support
Handlebar
Frame
Locknut on Stud
Upper Mounting
Hardware
Support
Clamp
To Next Page
Loading...
