EasyManua.ls Logo

Ariens Pro 28 - Ignition Switch Function; Primer Bulb Usage; Speed Selector Operation; Choke Control Operation

Ariens Pro 28
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 16
NOTICE: If belt squeals when impeller turns
freely, see Attachment Clutch/Brake
Adjustment on page 26.
Ignition Switch (120VAC start)
Operate the ignition switch
with the removable key. To
start the engine, turn the key to
Start (2). To stop the engine,
turn the key to Off (1).
Primer Bulb
Pushing the primer bulb in adds
fuel for easier engine start.
Refer to Starting and Shut Off
on page 19.
Speed Selector
Position the Speed Selector in
the appropriate speed notch to
control forward and reverse
travel.
Forward:
(6) Fastest
(1) Slowest
Reverse:
(1) Slow
(2) Fast
IMPORTANT: DO NOT change
motion from forward to reverse
with clutch engaged. Forward
speed can be changed without
declutching.
Choke Control Knob
1.Choke Closed
position: chokes off
air to engine for
easier start.
2.Choke Open
position: allows for
normal operation.
IMPORTANT:
Gradually open choke
after engine starts.
Throttle
The throttle controls the engine speed. To
increase or decrease the engine speed,
adjust to:
1. Fast
2. Part-Throttle
3. Slow
Electric Starter
The electric starter will start a properly
choked and cranked engine when the starter
button is pushed. Refer to Starting and Shut
Off on page 19.
Recoil Starter Handle
When pulled, recoil starter handle will turn
engine over.
IMPORTANT: DO NOT let recoil starter
handle snap back against starter.
Snow Clean-Out Tool
(Figure 12)
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller
blades have stopped rotating.
3. Remove the snow clean-out tool from
the auger housing and use it to remove
the clog from the discharge chute.
4. Replace the snow clean-out tool on the
auger housing.
Remote Deflector Control
Place deflector into position before operation.
DO NOT throw snow any higher than
necessary.
Place deflector remote in a forward notch to
throw snow lower. Place deflector remote in a
rearward notch to throw snow higher.
1
2
6
1
1
2
CHOKE
RUN
3
2
1
WARNING: Hand contact with the
rotating impeller is the most
common cause of injury associated
with snow throwers. Never use your
hand to clean out the discharge
chute.
Figure 12
Snow Clean-Out
Tool

Other manuals for Ariens Pro 28

Related product manuals