EN - 23
GENERAL LUBRICATION
(Figure 18)
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTICE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 32.
Sno-Thro should be lubricated (Figure 18) at
beginning of season or every 25 operating
hours.
Auger Shaft
To grease auger shaft, remove shear bolt
nuts and shear bolts per instructions in Shear
Bolts on page 24. Apply grease at the grease
zerks and then turn the auger assemblies on
the auger shaft. Replace shear bolts.
Apply oil to auger shaft end bushings.
To Next Page
Loading...
