WINDOW SLIDER KIT INSTALLATION
Your window slider kit has been designed to fit most standard “vertical” or “horizontal” window applications.
However, it may be necessary for you to modify some aspects of the installation procedures for certain types of
windows. The window slider kit can be fastened with screws.
NOTE: A plastic locking screw is holding the window slider kit together during shipment.
Prior to installation,remove the locking screw,adjust to desired length and use provided locking screw to
secure
NOTE: If the window opening is less than the minimum length of the window slider kit, cut the one without the hole
in it short to fit in the window opening. Never cut out the one with hole in window slider kit.
DOUBLE-HUNG SASH/SLIDING CASEMENT WINDOW INSTALLATION
1.Attach the window slider kit to the
window sash. Adjust the length of the
window slider kit according to the width of
window. Shorten the less than the
minimum length of the window slider kit
2.Close the window securely against the
window slider kit
3.Secure the window slider kit to the window
sash
Window Slider kit can be
secured
By inserting the locking
screw
Cut on opposite side
with the hole
D- Screw to lock window
kit in place
To Next Page
Loading...