FOLLOW ME(optional)
The FOLLOW ME function allows the room to be cooled according
to the room temperature,wherever the romote is located. The remote
control serves as a thermostat allowing for the precise temperature
control at its location.
●To activate the Follow Me function,point the remote control towards
The appliance and press the “function button”
●Press either the “Increase button” or “Decrease button” until
the “Follow me” symbol flashes on the LED screen.
●Press the “function button” again, the “Follow me”symbol will stop
flashing and illuminate on the LED screen
●The remote will display the actual temperature at its location.The remote
control will send this signal to the air conditioner at 20 minute intervals.
●If the unit does not receive the Follow me/Temp Sensing signal during a
25 minutes interval,the Follow me will be canceled and will need to be
reactivated.
●To cancel this function,press the “function button”.
●then press either the “Increase button” or “Decrease button” until the
“Follow me” symbol flashes on the LED screen,
●and then press the “function button” to confirm the cancellation. the symbol
“Follow me” will stop flash and disappear from the screen.
NOTE:The remote must be within 7 meters of the remote control receiver on
the air conditioner unit.Itshould not have any obstructions.
To Next Page
Loading...