REPAIR MANUAL
Page: 7
A 45 V
10. DRUM BELT
11. TOE KICK
• To remove Drum Belt, first remove the Right Side
Panel as described in Section 8 (Fig. 10-1). Then
disengage the Drum Belt from the Pulley Wheels
(Fig.10-2). Next, remove the two (2) Phillips screws
that attach the Bearing Block Cover to the Rear Panel
(Fig. 10-3).
• With the Bearing Block Cover removed, remove the
two (2) Phillips screws that attach the Drum Grounding
Strip (Fig. 10-4) then using a Needle Nose Pliers to
remove the Drive Pin (Fig. 10-5).
TECH NOTE: Be careful not to damage the Drive Pin,
since you will need to reuse it.
• Next, remove the Right Side Strut (A) (Fig.10-6). Now
separate the Rear Panel from the Drum and slide the
Drum Belt out and off (Fig. 10-6).
Fig. 10-1
Fig. 10-2
Fig. 10-3
Fig. 11-1
Fig. 11-2
• To remove Toe Kick (Fig. 11-1), remove the Left and Right Side
Panels as described in Section 8. With the Side Panels removed,
remove the two (2) Phillips screws that hold the Toe Kick in place
and slide the Toe Kick off from its mounting slots (Fig. 11-2).
Fig. 10-4
Fig. 10-5 Fig. 10-6
A
To Next Page
Loading...
