REPAIR MANUAL
5. CONTROL PANEL PROGRAM BOARD REMOVAL
• The Program Board is replaced as a complete assembly (Fig. 5-3).
Page: 6
Fig. 5-1
Fig. 5-2
• Next, release the three Program Board locking tabs and removed Program Board from the Control Panel (Fig. 5-2).
• To remove the Control Panel Program Board, first remove the Program Dial by carefully prying it out from the Control
Panel, making sure not to damage the knob or Control Panel (Fig. 5-1).
NOTE: The Control Panel does NOT have to be removed from the Washer to remove the Control Panel Program Board.
Fig. 5-3
AW 129 NA / AW 149 NA
To Next Page
Loading...
