Ariston AW 129 NA - Front Panel and Drum Boot Removal; Drum Boot

FRONT PANEL:
• First remove the Control Panel (see Section 4, Page 6).
• With the Control Panel removed, remove the two Phillips screws
located at the top left and right corners of the panel (Fig. 6-1).
• Next remove the Outer Drum Boot Retainer Spring and then
disconnect Door Locking Mechanism Wiring Harness (Fig. 6-2).
• Remove the lower Toe Kick and then the two bottom Phillips
screws (Fig. 6-3). The Front Panel can be lifted up and off from the
four panel alignment pins (Fig. 6-4).
DRUM BOOT:
• The Drum Boot is held to the Drum with a reusable Zip Retainer
Clamp (Fig. 6-4). Remove the Inner Drum Clamp by pushing down
on one of the clamp spring arms (Fig. 6-5).
TECH NOTE: When installing the Boot make sure to align the drip
edge at the 6 O’clock position (see Note in Fig. 6-4).
REPAIR MANUAL
Page: 7
6. FRONT PANEL & DRUM BOOT REMOVAL
Fig. 6-2
Fig. 6-1
Fig. 6-3
Fig. 6-5
Fig. 6-4
TECH
NOTE
Alignment
Pin
AW 129 NA / AW 149 NA