20 / GB
OPERATING MODES HEATING OR COOLING
(where present)
Press OK: the display visualises:
- Time program / Manual
- Summer / Winter / Cooling / O
- Complete menu
Turn the knob and select:
- Summer / Winter / O
Press the OK button. Turn the knob and select:
- ( ) SUMMER
production of domestic hot water, heating excluded.
- (
) WINTER
production of domestic hot water and heating
- (
) HEATING ONLY
exclusion of cylinder heating (where present)
- ( )
COOLING (where present)
domestic hot water production, cooling on.
- (
) OFF
system o , anti-frost function active. When the anti-frost fun-
ction activates, the following symbol appears on the display:
“
”. This function protects against frost build-up in piping.
Press the OK button to confi rm.
Press the OK button again to return to the previous visualisation.
Turn the knob and select:
- Time program / Manual
Press the OK button. Turn the knob and select:
- (
) TIME PROGRAM
the heating or cooling will work according to the programmed
hourly time schedule
- (
) MANUAL
the heating or cooling will work in the manual mode.
Press the OK button to confi rm.
Press the OK button again to return to the previous visualisation.
ROOM TEMPERATURE ADJUSTMENT
Depending on the chosen operating mode, programmed or ma-
nual. .
Room temperature adjustment in manual mode
Turn the knob to set the desired room temperature value.
The display will visualise the set value.
Press the OK button to confi rm.
The display returns to the previous visualisation.
Scheduled room temperature adjustment programming
During operation in scheduled programming mode, the set room
temperature can be changed temporarily.
Turn the knob to set the desired room temperature value. Press
the OK button.
The display shows the set temperature and the time at which you
want the change to end.
Turn the knob to set the change end time and press the OK but-
ton to confi rm.
The display shows the symbol “
” alongside the desired tem-
perature value set for the change period.
Press the back button “
“ to exit adjustment without saving the
changes.
The SENSYS system interface will maintain the temperature val-
ue until the end of the set time period, when the pre-set room
temperature is restored.
Setting the date and time
Setting the date and time
Modifying the room temperature
Scheduled room temperature adjustment programming
To Next Page
Loading...
Need help?
General
