Need help?Do you have a question about the Ariston NIMBUS COMPACT M NET and is the answer not in the manual?
General| Refrigerant | R32 |
|---|---|
| Energy Class DHW | A+ |
| Wi-Fi Connectivity | Yes |
| Remote Control | Yes |
| Air Filter | Yes |
| Type | Heat Pump |
| Power Supply | 230V/50Hz |
Explanation of safety warning symbols used in the manual.
Information on product compliance with European directives.
Procedure for cleaning the heating system before operation.
Requirements for water quality and hardness for system operation.
Components that make up the Nimbus Compact M system.
Physical dimensions and weight specifications for external units.
List of available external unit models for the system.
Physical dimensions and weight specifications for the FSP 1 Zone internal unit.
Diagram and list of components for the FSP 1 Zone internal unit.
Physical dimensions and weight specifications for the FSP 2 Zones internal unit.
Diagram and list of components for the FSP 2 Zones internal unit.
Graphs showing operational limits for cooling and heating modes.
Graphs for available pressure and pressure drops at the external unit.
Graphs for available pressure at the internal unit outlet.
Table showing compressor frequency ranges for different heat pump sizes.
Technical specifications for the system interface.
Details on energy efficiency contributions and product fiche validity.
Guidelines for positioning and installing the outdoor sensor.
Requirements for qualified installers and placement considerations.
Diagrams showing required minimum distances for installation.
Steps for opening lateral passages and removing the front panel.
Internal unit positioning, clearances, and safety valve drain.
Procedures for filling the system, expansion vessel, and startup.
Checks required before making water circuit connections.
Diagram and guide for connecting internal and external units.
Description of 1 Zone and 2 Zone FSP system configurations.
Specific safety advice for under-floor heating installations.
Important safety precautions for electrical connections.
Table detailing electrical connection requirements for external units.
Electrical supply and connection data for FS zone configurations.
Safety warnings and diagrams of external unit terminal blocks.
Internal unit terminal connections and safety warnings.
Guidance on connecting internal and external units, including notes and warnings.
Electrical wiring diagrams for 1-phase and 3-phase external units.
Electrical wiring diagrams for 3-phase and 1-phase external units.
Guidelines for installing the system interface on the wall and connecting it.
Explanation of interface symbols, buttons, and LED indicators.
Initial setup steps including language and time configuration.
Accessing technical settings and navigating the system menu.
Configuration of heating modes, noise reduction, and hot water boost.
Settings for external inputs and outputs like HV inputs.
Manual operation of components and system test functions.
Configuration parameters for the floor drying cycle.
System data, diagnostics, and network settings.
Configuration of thermoregulation for Zone 1.
Setting the heat request mode for the system.
Parameters for Zone 1 cooling temperature range and thermoregulation.
Routine maintenance checks and user responsibilities.
Safety precautions for hydraulic connections.
Explanation of antifreeze functions for internal and external units.
List of internal unit error codes and their troubleshooting.
List of external unit error codes and troubleshooting steps.
List of inverter error codes and their descriptions.
Information from data plates and refrigerant specifications.
To Next Page