18 1X-X3 Operation Manual
Control panel operation
User levels
For your safety, access to some features of this product are restricted by user
levels. The access privileges of each user level are described below.
Public user
The public user level is the default user level.
This level allows basic operating tasks, such as responding to fire alarms or fault
warnings at the control panel. No password is required.
See “Public user level operation” below for more information.
Operator user
The operator user level allows additional operating tasks that command the
system or perform maintenance functions. It is reserved for authorized users who
have been trained to operate the control panel.
The default password for the operator user level is 2222.
See “Operator user level operation” on page 20 for more information.
This is a restricted user level, protected by password security. To enter the
operator user level, enter the password using the numeric keypad, and then
press Enter.
A long beep and a steady Reset LED indicate that the correct password was
entered and that the operator user level is active. Three short beeps
accompanied by a flashing General Fault LED indicate that an incorrect
password was entered.
The control panel automatically exits the operator user level and reverts to the
public user level after 5 minutes if no button is pressed.
Note: The control panel is available with an access key option. The key switch is
located on the panel cover. With this option, either the key or the password can
be used to enter the operator user level.
Public user level operation
Public user level operations are those that can be performed by any user. No
password is required to perform tasks at this level.
Public user level operation lets you:
• Acknowledge a system event and silence the control panel buzzer
• Cancel an active fire sounders delay
• Cancel an active fire routing delay
• Perform a control panel LED and buzzer test
To Next Page
Loading...
Need help?
General
