ATS4000 Installation and Quick Programming Guide 15
1. Output number 1. Event flag number
2. Timezone to control output
3. Active or Inactive during TZ
4. Invert output
19. Area linking
20. System code
10. Program text
11. Version number
12. Lamp test
13. Time zones
14. Reset defaults
15. Alarm group restrictions
16. Output mapping
17. Auto Arm/disarm
18. Area assign to vaults
1. System code 1
2. Card offset 1
3. System code 2
4. Card offset 2
1. Alarm group restriction n° 1. name
2. Timed disarm areas
3. Areas to arm/reset
4. 1st Alternate timed disarm area
1. Program text words
1. Select the device to
get information on
1. Select timezone 1. Program start time, hours.
2. Program start time, minutes
3. Program end time, hours.
4. Program end time, minutes
5. Days
1. Select default option
5. 1st alternate Areas to arm/reset
6. 2nd Alternate timed disarm area
7. 2nd alternate Areas to arm/reset
1. Auto Arm/Disarm program 1. Timezone to arm/disarm
2. Alarm group to auto arm/disarm
21. Zone shunts 1. Shunt timer number 1. Zone number to shunt
2. Output number to start shunt
3. Shunt time
4. Shunt warning time
5. Shunt event flag
6. Shunt warning event flag
7. Door open command starts shunt
8. Shunt zone when disarmed
9. Shunt zone when armed
10. Cancel Door event flag
11. Zone holds event flag at 2 seconds
12. Entry/exit shunting
13. Log door open/close
To Next Page
Loading...
