AZI Sales/Customer Service 800-528-7411 or 602-470-1414 or support@azic.com Page 18 of 26
To load difficult samples more easily, remove the sample pan from the instrument
after the correct amount of sample has been placed on the pan, place the filled pan on
a level work surface, and spread the sample by gentle shaking or tapping, or use a
small flat brush, spoon, knife or spatula (depending on the consistency of the sample),
and then replace the loaded sample pan on the pan support. An even layer of sample
across the pan will reduce test times and increase precision of results. Do not spread
granular products with a spoon as the particles compress even under gentle pressure
affecting test times and results. Transport samples in an airtight container to prevent
moisture gain or loss through contact with air.
• Close the lid, and the instrument weighs
the sample.
• The test proceeds to dry the sample.
• The test finishes once the ending criteria
has been met.
• Open the lid and remove the sample.
• Place a new/clean sample pan on the pan
support to get ready for the next test.
• Close the lid when the heat chamber is
cool.
If desired, run 5 or more tests to obtain reliable information about the standard deviation
of a typical result. Each test result is automatically saved, and the instrument can
calculate the mean, standard deviation, and relative standard deviation through the Test
Results menu.
To Next Page
Loading...
Need help?
General
