15
Care of your TENOR
How often the following actions are taken,
depends on how often the equipment is used.
Unless otherwise stated, before each and every
use follow the cleaning, care and inspection
procedures described in this section.
For cleaning your lifter, equipment and
accessories wipe down with a damp cloth using
warm water to which a mild detergent has been
added.
For disinfection of contaminated lifters,
equipment and accessories, use the preferred
method of wiping the product completely with
“hard surface disinfectant wipes” that are supplied
impregnated with a mild detergent.
A rubbing action will be necessary when using
the wipes to promote effective disinfection of the
surfaces.
Servicing Advice
Spare parts, if required, are available from Arjo
or their approved distributors. Parts list and
circuit diagrams are available from Arjo or their
approved distributors upon request.
Special tools are required for certain component
replacement.
UK LIFTERS ONLY:
Important new legislation
came into force on 5th December 1998, which has an
impact on the schedule of service for your resident
lifter(s), variable height baths and other raising and
lowering equipment. The Lifting Operations and
Lifting Equipment Regulations (LOLER) 1998 and
the Provision and Use of Work Equipment Regula-
tions (PUWER 98) must be satisfied by the duty
holder. A scheme of six monthly through examina-
tions has been devised to comply with the law and
details can be obtained from Arjo Service UK.
The simplest, safest and most effective way to
maintain your product in good working order, is to
have it methodically and professionally serviced by
an Arjo approved engineer using Arjo approved
spare parts
WARNING
It is recommended that resident lifters,
equipment, accessories and slings
supplied by Arjo are regularly cleaned
and / or disinfected between each
resident use if necessary, or daily as a
minimum. If the slings, lifters and
equipment need cleaning or are
suspected of being contaminated,
follow the cleaning and / or disinfection
procedures below, before re-using the
equipment. This is especially
important when using the same
equipment for another resident to
minimize the risk of cross infection.
WARNING
Cleaning and disinfection products
must be used in accordance with the
manufacturer’s instructions and
suitable eye, hand and clothing
protection must be worn at all times
when handling disinfectants.
CAUTION
Do not use the product in wet areas,
as this could cause problems with
electrical components or internal
corrosion.
If a hot air dryer is used to dry the lifter,
the temperature must not exceed 90°C
(194°F)
Do not use petroleum based solvents
or similar. This may damage plastic
parts.
WARNING
Arjo recommends that the Tenor is
maintained at regular intervals. See
Arjo Preventive Maintenance
Schedule.
To Next Page
Loading...
