What to do if Arjo Voyager Duo Medical Equipment beeps and stops lifting?
If the Arjo Medical Equipment ceiling lift cassette emits a beep during use and stops lifting (but you can still lower it), the batteries are likely low. Return the ceiling lift cassette to the charging station to recharge them.
Why does Arjo Medical Equipment start and stop?
If your Arjo Medical Equipment unit starts and stops repetitively, it might be due to the load exceeding the safe working limit. The overload protection on the motor prevents operation when the load is too heavy.
What to do if Arjo Voyager Duo goes past charger?
If the Arjo Medical Equipment ceiling lift cassette passes the clip on the charging station or goes in the wrong direction when returning to charge, clean the contact blades of the charging station with mild detergent. Then, manually pass the ceiling lift cassette through the charging station once before retrying the return to charger function.
Why is Arjo Voyager Duo flashing yellow?
If the charging light on the Arjo Medical Equipment ceiling lift cassette continues flashing yellow and doesn't turn solid even after overnight recharging: * Test the two contact points on the charging station with a voltmeter (it should read between 26 and 30 volts VDC). * If available, try another integrated clip-on charging station. * Replace the batteries with new ones.
What does solid red light mean on Arjo Voyager Duo Medical Equipment?
If the red light on your Arjo Medical Equipment is solid, the ceiling lift cassette is likely under overheat protection. Wait 10 to 30 minutes until the red light turns off, then press the “UP” button to use it again.
Why Arjo Voyager Duo Medical Equipment charger indicator doesn't light up?
If the charger indicator (yellow) on the Arjo Medical Equipment ceiling lift cassette does not light up when the lift is on the charger, check that the charger is plugged into a standard outlet and that the outlet has power. The green light on the clip-on charging station indicates that it is functioning.
What to do if Arjo Voyager Duo goes past charger (four-way motor)?
If when you press the button to return the Arjo Medical Equipment ceiling lift to its charger (four-way motor only), the ceiling lift goes past the charger: * Verify that the contact blades of the cassette are intact and making good contact with the clip on charging station. * The charger either has no power or is not working properly (the contacts are defective).
Why Arjo Voyager Duo batteries die quickly?
If the Arjo Medical Equipment batteries are always dead after only a few transfers (3 to 5): * Verify the function of the ceiling lift charger and the contact plates on the clip-on charging station. * Replace batteries with new ones. It is important to always change both batteries at the same time.
General| Brand | Arjo |
|---|---|
| Model | Voyager Duo |
| Category | Medical Equipment |
| Language | English |
Explains how to use the manual and provides important safety information.
Details how to find the unit's identification number (specification, model, serial number).
General safety guidelines, including shock prevention and careful operation.
Precautions regarding battery disposal and prevention of fire hazards.
Specifies the safe working load limits for the lift.
Identifies components of the lift cassette and charger station with a diagram.
Describes the wired hand control unit for the lift.
Details the universal charging system and its compatibility with AC outlets.
Explains the need for regular maintenance and indicator lights for service.
Step-by-step guide for accessing and replacing the lift's batteries.
Instructions for removing and installing the lift's strap.
Guide for replacing the lift's handset.
Steps for replacing the main circuit board of the lift.
Procedure for replacing the high limit switch.
Steps to access and replace the horizontal motor of the lift.
Instructions for installing the SWL key to increase lifting capacity.
Procedure for removing the SWL key and reverting to lower capacity.
Outlines recommended maintenance intervals and tasks for the lift.
Tasks for users to perform regular inspections of the lift.
Details inspections that require a certified service technician.
Instructions for cleaning the lift enclosure and track.
Guidelines for inspecting the lift strap for wear and damage.
Procedures for inspecting the lift's emergency brake system.
Recommendations for safe handling and storage of the lift.
General information about Arjo batteries and replacement considerations.
Steps to verify the charger is functioning correctly.
Guidance on inspecting and caring for lift slings.
Requirement for annual inspection by a qualified technician.
Details on the unit's maintenance monitor and technician authorization.
Problem/solution guide for common issues with the lift.
Provides detailed physical dimensions of the lift unit.
Information on the lift's compliance with EMI standards and interference reduction.
Guidance on immunity to electromagnetic interference and separation distances.
To Next Page
