Need help?Do you have a question about the Arjo Sara Flex and is the answer not in the manual?
General| Total Height | 150 cm (59 inches) |
|---|---|
| Total Length | 1060 mm (41.7 in) |
| Length | 1060 mm (41.7 in) |
| Base Length | 1060 mm (41.7 in) |
| Material | Steel |
| Power Source | Battery |
| Battery Voltage | 24V |
Description of Sara Flex as a mobile standing and raising aid for lifting and transferring patients in various care environments.
Critical safety warnings regarding patient supervision, small parts, strangulation risk, and working load limits.
Six steps for initial setup, including visual checks, reading IFU, and verifying functions like emergency lowering.
Two steps to perform before each use: visual inspection and battery level check.
Overview of the hand control and mast-mounted control panel, including button functions for lifting and leg spread operations.
Details on how to activate and deactivate the emergency stop button to cut or restore power to electrical components.
Instructions for pressing the green power button to switch the Sara Flex on.
Procedure for activating the emergency lowering function to safely lower the patient in case of power failure.
Explanation of the overload protection feature that stops the lift's motion when the safe working load is exceeded.
Description of the anti-crush system that stops motor movement if the lifting arm encounters an obstruction.
Steps for preparing the Sara Flex and patient, including sling selection, brake application, and patient information.
Eight steps detailing how to position the patient in the Sara Flex, including foot placement and handle use.
Five steps for raising a patient from sitting to standing position using the hand control and checking supports.
Two steps for completing a patient transfer away from a wheelchair, involving pulling the lift and adjusting chassis legs.
Eight steps for weighing a patient without accounting for sling weight, including zeroing the scale.
Seven steps for weighing a patient with the sling attached, including handling negative weight displays.
Information on the battery charge indicator, low battery warnings, and behavior when the battery is nearly empty.
Step 1: Placing the Sara Flex in an ergonomic working position for cleaning.
Steps 4-8: Spraying detergent, removing it with towels, and drying all parts of the Sara Flex.
Steps 9-14: Spraying disinfectant, allowing contact time, removing it, and drying all parts.
Routine cleaning and disinfection of the Sara Flex immediately after usage.
Test all functions of the Sara Flex, including lifting, lowering, leg spread, and brakes.
Verify the operation of the Emergency Stop, Power Button, and Emergency Lowering Handle.
Schedule annual servicing of the Sara Flex by qualified personnel according to the Maintenance and Repair Manual.
To Next Page