28
Cleaning/Disinfection
Follow this procedure between every use.
Follow these 14 steps
Preparation (step 1)
1. Place Sara Flex in an ergonomic working
position.
Removal of visible contamination (step 2-3)
2. Wet a disposable towel with water and remove
visible stains and soil on Sara Flex.
3. If heavily contaminated, please use brush and
towels to remove all visible contamination.
Cleaning (step 4-8)
4. 6SUD\ZLWK$UMRYHUL¿HGGHWHUJHQWVHH
“Detergents/Disinfectants” on page 27 on all
parts of Sara Flex and on the hand control.
5. Wet a disposable towel with water and remove
all traces of the detergent. For the leg support
(A) and leg strap (B), use a disposable towel to
remove the detergent and for the footplate (C),
you may need a brush. (See Fig. 47)
6. If the detergent cannot be removed, spray water
on the affected part and then wipe it off with
disposable towels.
7. Repeat until all of the detergent has been
removed.
8. Let all parts dry.
Disinfection (step 9-14)
9. 5HSHDWVSUD\LQJZLWKWKH$UMRYHUL¿HG
disinfectant on all parts and on the hand control.
10. Allow the disinfectant to stay on the parts
according to manufacturer’s recommendation.
11. Remove all traces of disinfectant, using new wet
disposable towels. For the leg support (A) and leg
strap (B), use a disposable towel to remove the
disinfectant and for the footplate (C), you may
need a brush. (See Fig. 47)
12. If the disinfectant cannot be removed, spray with
water on the affected part and wipe it off with
disposable towels.
13. Repeat until all of the disinfectant has been
removed.
14. Let all parts dry.
Fig. 47
A
B
C
To Next Page
Loading...
