Arjo Sara Flex - Transfer from Sara Flex to Bed;Chair

19
Fig. 28
Fig. 29
Transfer from Sara Flex to Bed/Chair
(11 Steps)
1. Apply the brakes on the wheelchair, if applicable.
2. Adjust chassis legs if needed to go around bed/
chair. (See Fig. 28)
3. Lower the patient onto the surface of bed/chair.
(See Fig. 29)
4. Make sure the patient is positioned correctly on
the bed/chair.
5. Detach the sling from Sara Flex.
6. Have the patient release their hands from patient/
resident handles.
7. Detach leg straps, if applicable.
8. Have the patient lift his/her feet off the footplate,
assist if needed.
9. Pull the Sara Flex away from the patient.
10. Remove the sling from the patient
11. Clean the Sara Flex after the transfer is complete,
according to “Cleaning and Disinfection
Instructions” on page 27 or according to local
guidelines.