ARKSCAN ES301 - Memory Mode; Enable Memory Mode; Disable Memory Mode; Data Output

- 25 - - 26 -
MEMORY MODE
Data Output Method
You may output data ONLY when memory is enabled (page 15).
To output stored data via Wireless, please do the following:
1. Scan [WIRELESS]
2. Scan [OUTPUT DATA]
To output stored data via USB-VCP, please do the following:
1. Install VCP driver (available on CD)
2. Connect the scanner & host with USB cable
3. Scan [USB-VCP]
4. Save data as .csv by “Covert to CSV.exe” (available on CD)
*
For memory version only
. R001$
*.R001$*
ENABLE MEMORY
. R002$
*.R002$*
DISABLE MEMORY
. R005$
*.R005$*
DELETE LAST RECORD
. R004$
*.R004$*
CLEAR ALL RECORD
OUTPUT DATA
For memory version only
. R003$
*.R003$*
OUTPUT DATA
Delete Last Record/ Clear All Record
Once enabled, the scanner will stop sending data via Bluetooth
and begins storing data into the internal flash disk (2MB)
. C006$
*.c006$*
USB-VCP
. C035$
*.c035$*
WIRELESS