1Introduction
IVS 102
Software version: 3.2.x
This guide can be used with all IVS 102 frequency converters with
software version 3.2.x.
The actual software version number can be read from
par. 15-43
Software Version
.
1.1.1 Copyright, Limitation of Liability and Revision Rights
This publication contains information proprietary to Armstrong. By accepting and using this manual the user agrees that the information contained herein
will be used solely for operating equipment from Armstrong or equipment from other vendors provided that such equipment is intended for communication
with Armstrong equipment over a serial communication link. This publication is protected under the Copyright laws of Denmark and most other countries.
Armstrong does not warrant that a software program produced according to the guidelines provided in this manual will function properly in every physical,
hardware or software environment.
Although Armstrong has tested and reviewed the documentation within this manual, Armstrong makes no warranty or representation, neither expressed
nor implied, with respect to this documentation, including its quality, performance, or fitness for a particular purpose.
In no event shall Armstrong be liable for direct, indirect, special, incidental, or consequential damages arising out of the use, or the inability to use
information contained in this manual, even if advised of the possibility of such damages. In particular, Armstrong is not responsible for any costs, including
but not limited to those incurred as a result of lost profits or revenue, loss or damage of equipment, loss of computer programs, loss of data, the costs
to substitute these, or any claims by third parties.
Armstrong reserves the right to revise this publication at any time and to make changes to its contents without prior notice or any obligation to notify
former or present users of such revisions or changes.
IVS 102 Operating Instructions 1 Introduction
MG.12.E2.02
3
1
To Next Page
