Armstrong The Brain DRV40 User Manual

17
Armstrong International
Parc Industriel Des Hants-Sarts, 2ème Avenue No. 4, Haerstal, B-4040, Belgium
armstronginternational.com/brain
Connect and secure the 8 pin plug to the back
of the Electronics Module.
Important! Do not t the 4 pin plug at this
stage. To prevent a back EMF the system
must be ooded with water before the 4 pin
plug is tted.
Connect the power cable to the primary power
supply.
A separate, permanently connected supply
must be taken from the ring main to the
appliance through a 3 Amp double pole
switched fuse spur providing a minimum of
3 mm contact separation gap in each pole. This
disconnection device should be located near to
the DRV40 and identied to its purpose.
Commission the DRV40 and recirculation system using the following instructions...
6
7
5
Power Cable

Armstrong The Brain DRV40 Specifications

General

Brand	Armstrong
Model	The Brain DRV40
Category	Control Unit
Language	English