ARP Control v5.x Troubleshooting Guide 0 © 2013-2020 ARPC L.L.C. All rights reserved.
6 04/20/202
When in adjustment mode, each subsequent press of the
SetUp button will increment the value by 1.
Store any setting change, 2.22 Store Setting
2.15 Temperature Units
The boiler temperature units can be changed from
degrees Celsius (C) to degrees Fahrenheit (F). C is the
default value.
Press the SetUp button to change the setting. Following
is an example of the display for each setting:
Please see 9.1 for further info.
Store any setting change, 2.22 Store Setting.
2.16 Set-Point Function Setting
The ARP has three Set-Point control functions as follows:
1) C-H is the Set-Point control high mode. This is the
default mode and would be considered the plug-n-play
mode. This setting works on most refrigerators.
2) C-L is the Set-Point control low mode. This mode is for
fine tuning your control so that the maximum protection
for your fridge is achieved on smaller refrigerators.
Please see 2.4 AtO Reading
and section 9.2
On/Off
Display
SetUp
3) The PID Set-Point control function is used on
particular refrigerators. A partial list of cooling units that
may need this control setting are some Dutch Aire
(Amish) cooling units, Norcold 1210 & 2118 cooling units
made after the year 2013, and some older Dometic
cooling units.
Please use the Contact Us form on www.ARPrv.com
website for any questions or concerns.
To Next Page
Loading...
