FAB
I
ntelligent
C
ontrollerr
Step 1: Use the external telephone to dial the telephone numbers of the FAB-
connected telephones, to connect FAB, and then you will hear the voice prompt
as āplease enter the passwordā.
Step 2: Enter the password of the FAB correctly.
Step 3: Dial P0 - P9 controlling signals to control the output of FAB. The RS
block input has telephone two-tone pulse signals or rather P0 -P9. During the
programming, the input of RS needs to be set as P0 - P9 so as to implement the
controlling function of the telephone function block.
b. Telephone alarm
When the input signal of this function block is 1, the FAB will automatically
dial the preset number.
This function is applicable to the cases that a voice prompt is required. It is
necessary to make a recording beforehand.
This feature is used in the cases that both auto-dialing and auto-alarming are
required. FAB, matching with AF-MUL/AF-MUL-D, will achieve functions of
telephone control and voice response.
When you program the TEL clock on the LCD panel, at the end of the tele-
phone number you should addā:ā, which marks of the end of the telephone
number.
3.2.12 PLAY (The Voice Module needs to be used in conjunction with FAB)
Figure of FAB Pin Description
On
When ON is 1, Output Q is 1, i.e. the
voice section is turned on for broadcast-
ing. The following inputs are at option :
I1 ~ IC, Q1 ~ Q8, HI, LO, M00~M126,X.
OFF
When OFF is 1, Output Q is 0, i.e. the
voice section is turned off. The follow-
ing inputs are at option : I1 ~ IC, Q1 ~
Q8, HI, LO, M00~M126, X.
This function is applied to the cases that the voice prompt is required.
38