Array electronic AF-10MR-A User Manual

FAB I
ntelligent
C
ontrollerr
Note
If the week system is selected, then only T1 and T2 need to be set because
the system will ignore D whether it has been set or not.
4. Set the Telephone Blocks
When a Telephone Block is selected, LCD panel will be displayed as Fig. 4.13
shows. Set the input on the left of the block rst, then move the cursor to the
output on the right and press.
Fig. 4.13
After OK key is pressed, the following will be on the LCD panel:
Fig. 4.14
Press ， ， ， keys to move the cursor to select the digit of the
telephones (as many as 25 digits can be set) and press
, keys to change
the value to set each digit of the telephone number in turn. After the number is
set, move the cursor to the last digit of the set number and press
to exit.
Note:
After the setting of the telephone number, “:” must be added to mark the
end of the number.
Phone Code
0000000000
0000000000
00000
48

Array electronic AF-10MR-A Specifications

General

Brand	Array electronic
Model	AF-10MR-A
Category	Controller
Language	English