When compare mode is set to Interleave, every other line is replaced by
content from the loaded file. This is useful for lining up shots, as the
frame will flicker until the stored and the live image are perfectly lined
up. Otherwise, pressing COMPARE completely overlays the loaded
image over the live image.
11.1.5.6 User Setups
A user setup is a profile of the current settings on the ALEXA that can
be saved to the SD card. User setups can be given custom names,
saved to the SD card and loaded onto multiple ALEXAs.
Rather than resetting the camera to its factory default settings, a user
setup can be used to reset the camera to a user's default settings.
A user setup contains all parameters set in the camera except files that
have been transferred via SD card, specifically frame lines and ARRI
Look Files. These are not affected by loading a user setup and are only
cleared by performing a factory reset.
Requirements:
formatted SD card loaded in the SD card slot on the ALEXA
To create a user setup:
Set all the desired parameters on the ALEXA.
To save a user setup:
1. Press the MENU button.
2. Use the jogwheel to select User Setups.
3. Select Save current setup.
To Next Page
Loading...
Need help?
General