The master camera will initially distribute its settings to the slave
camera. Once this is done, settings can also be changed on the slave
camera, and the change will take effect on both cameras. This is useful
if the master camera's controls are not accessible.
If a camera is set to ETH master or ETH slave, but is not connected to
another camera, a warning is displayed on the STATUS Info screen.
Synced settings
The following settings are synced when syncing two ALEXAs:
WB>White Balance + CC Tint
EI>Exposure Index
FPS>Sensor FPS
FPS>HIGH SPEED>High Speed mode
2
SHUTTER>Shutter Angle
COLOR>Gamma>SxS
COLOR>Gamma>REC OUT
COLOR>Gamma>MON OUT
COLOR>Gamma>REC OUT
COLOR>Gamma>EVF
COLOR>Gamma>LOG C film matrix
MENU>Recording>Internal>Mode
MENU>Recording>Internal>Codec
MENU>Recording>Internal>High Speed codec
2
MENU>Recording>REC OUT>Frame rate
MENU>Recording>REC OUT>HD-SDI format
MENU>Recording>REC OUT>Scan format
MENU>Recording>REC OUT>Output range
MENU>Recording>REC OUT>REC OUT fps sets sensor fps
MENU>Recording>REC OUT>SDI remote
MENU>Recording>REC OUT>Vari flag
MENU>Monitoring>EVF>Status info
MENU>Monitoring>EVF>Surround view
MENU>Monitoring>EVF>Surround mask
To Next Page
Loading...
Need help?
General