Pay attention during setup and the entire operation that no fingers or limbs end up
between the outer yoke and inner ring.
A high kinetic force can result between the outer and inner ring, depending on the weight
and length of the camera.
Serious injuries can result through negligence. If this does happen then, cut off the
power supply straight away and seek medical attention if necessary.
Keep in mind that the SRH-3 & SRH-360 stabilized remote head is a fully stabilized
Gimbal based device with a payload capacity of 30kg / 66 lb.
The amount of available torque is very high.
To Next Page
Loading...
