34 Troubleshooting
Abnormal color or noise on the monitor
•
Unplug and then re-plug the HD-SDI cable between the
receiver and the monitor.
•
Unplug and then re-plug the SDI cable between the
transmitter and the source.
•
Bring the transmitter and receiver closer together but no
closer than 1 meter.
•
Keep the number of solid walls between the transmitter
and receiver to a minimum.
•
Power cycle the system.
No audio
•
Check the mute and audio volume settings on the monitor.
•
Check if the audio format setting on the source is
incompatible with system. Change the source to output
PCM 2.0, DTS or Dolby Digital.
•
Make sure the pin #2 on the DIP switch is down.
To Next Page
Loading...