ARRI WVT-1 - Radio System; 1 Antenna Connector; 2 Color Coding; 3 Setting the Region of the Wireless Video Function

Appendix 45
13.10 Radio system
13.10.1 Antenna connector
The radio connection is established via the antenna mounted
to the antenna connector. The radio module inside could be
damaged by electrostatic discharge via the open connector. We
recommend using the originally supplied antenna only.
13.10.2 Color coding
ARRI WVS uses dual-band (2.4 and 5 GHz) high performance
antennas that work with all three radios on the ALEXA LF and
ALEXA SXT W.
WVT-1, WVR-1 and WVR-1s use the 5 GHz unlicensed
frequency band.
The antennas can be attached to the wireless video (blue, 5
GHz), WiFi (white, 2.4 GHz) and ARRI ECS (white, 2.4 GHz)
antenna connectors.
NOTICE
ARRI ECS antennas with no color coding will only work
with the ARRI ECS radio, and should not be attached to the
wireless video connectors.
13.10.3 Setting the region of the wireless video function
Setting the region of the wireless video modules can only be done
by ARRI Service Centers. Please note that only devices with the
same region setting are compatible with each other.
CAUTION!
Wireless region settings specify where the wireless function
can be used in compliance with local regulations. It may
be illegal to use the wireless function in a region other than
specified in the setting. Please ensure that the region is
configured correctly, e.g. when traveling.