Arris Touchstone CM8200B - Page 25

Please note
• The short coaxial cable connects
your coaxial wall outlet to the
splitter marked ‘IN’. The long
coaxial cable connects the end
of the splitter marked ‘OUT’ to
your nbn
™
connection box
•
As coaxial cables conduct
electricity, you should never
disconnect, tamper with or alter
the coaxial connection without
following the steps outlined in
this guide or consulting your
service provider
• The coaxial cable should not be
pinched, kinked, or bent sharply
– this can cause a break or short
in the cable (which may have
to be replaced, and charges
may apply)
• When you’re ready to cancel
your existing internet service,
contact your service provider
• When your existing pay TV or
cable internet service has been
cancelled, you should remove the
splitter so your nbn
™
connection
box is connected directly to
your coaxial walloutlet
Before you begin
Please check with your service provider that your pay TV or existing
cable internet service is supported by an
nbn
™
connection.
This diagram gives you an overview of how
your equipment will be set up.
The following pages will step you through
the process of setting up and connecting
your equipment to thenbn
™
network.
Connection with pay TV
or existing cable internet
3 Connection with pay TV or existing cable internet